FIX LOOSE DODGE TAIL LIGHT LENS RAM AND SOME CARS
How to Glue a Taillight Lens
Ignoring even a small crack in a taillight lens can cause plenty of trouble for you in the future. Besides the obvious problem of perhaps receiving a ticket for the broken lens, a less obvious problem is water damage. Water can creep into the smallest opening, and if left unchecked, it can fog your taillight assembly interior and eventually short the taillight out. You can repair taillight lenses for much less money than buying a new assembly from the auto parts store, and it only takes minutes to do.
Clean the taillight lens assembly thoroughly by spraying cleaner on a rag and wiping down the lens.Do not allow any liquid to get inside the housing.
Remove the lens from the housing using the appropriate screwdriver.If the lens is glued to the housing, do not try to pry it off as that will likely break it. Instead, remove the entire taillight assembly and follow these directions to remove the lens from the housing without damaging it.
- Heat a kitchen oven to 200�F (99.3�C), and position oven rack in lowest position.
- Line a baking sheet large enough to hold the assembly with foil, and place the assembly on the baking sheet with the plastic lens facing up. Place in the oven for 15 to 20 minutes.
- Remove the baking sheet and assembly using oven mitts and carefully, using a flat edged screwdriver, pry the plastic lens from the housing. Remove the soft strings of glue from the edges of the lens while it is still warm using a sharp box cutter.
Wipe down the inside of the housing and the lens using a dry cloth.
Sand the edges of the crack using #200 fine grit sandpaper to give the adhesive a rough surface to cling to.
Apply a fine line of plastic glue along the crack, holding the pieces together with your hands for a minute to allow the glue to set up.If necessary, apply a second line of glue when the first one dries. You want the crack to be totally filled and even with the surface of the lens. If you apply too much glue, sand off the excess using #200 fine grit sandpaper.
Apply a line of plastic glue along the edges of the lens before replacing it in the housing and fastening down the screws.
Reattach the assembly to the car if necessary.
QuestionWhat kind of glue can I use to cover the cracks?Community AnswerGorilla Glue works best for the cracks. Be sure to get the clear glue, otherwise you will have yellow all over the lens.Thanks!
- A heavy duty hair dryer might work to loosen the adhesive on the lens rather than using the oven.
- You can buy special adhesive made for gluing plastic lenses at an auto parts store, or you can use the old fashioned glue used for plastic models, usually found behind the counter in hobby shops.
- Make sure the kitchen is well ventilated before placing plastic parts in the oven.
- Do not use a cyanoacrylate based adhesive to glue plastic taillights, as it will eventually eat through the plastic.
Video: Bondic - Liquid Plastic Welder - Tail Light Repair
Are doctors taking miscarriages seriously
How to Generate Employee Referrals
What does this mean for Markle and Harry
Now Playing: The only piece of advice Anil Kapoor ever gave Harsh
How To Use Olive Oil To Combat Oily Skin
How to Convince a Doctor to Take Rheumatoid Arthritis Symptoms Seriously
How to Prepare for a Social Work Interview
What is the best reading app for Kindles and iPads
Back to 90: adidas Originals e AW LAB presentano le nuove FALCON e lo fanno con un evento esclusivo super anni 90
The 10 Best Celebrity Haircuts of 2014
Jenny Packham’s SpringSummer 2019 Collection Abounds With A-List Worthy Dresses
10 Best Fuchsia Lipsticks Available In India
Woman Crashes Her Own Funeral After Husband Paid to Have Her Killed